I have it on my workbench and plan to add i/o ports (joystick, serial, cassette, DAC / audio output) to the front panel along with monitor controls, 6 bit DAC status LEDs, power and reset buttons, a speaker with volume control, a DAC voltage meter and perhaps a few other things today.
My SepTandy project for 2023
-
Danniielle
- Site Admin
- Posts: 187
- Joined: Sun Jul 23, 2023 7:40 pm
- Location: Adelaide
- Contact:
My SepTandy project for 2023
October is almost upon us and SepTandy 2023 is coming to a close. My primary CoCo based project for this SepTandy is to finally get my CoCo D (CoCo 3 in a Model 4 case) project finished.
I have it on my workbench and plan to add i/o ports (joystick, serial, cassette, DAC / audio output) to the front panel along with monitor controls, 6 bit DAC status LEDs, power and reset buttons, a speaker with volume control, a DAC voltage meter and perhaps a few other things today.
I have it on my workbench and plan to add i/o ports (joystick, serial, cassette, DAC / audio output) to the front panel along with monitor controls, 6 bit DAC status LEDs, power and reset buttons, a speaker with volume control, a DAC voltage meter and perhaps a few other things today.
-
John_Thompson
- Posts: 1
- Joined: Sat Aug 19, 2023 10:31 pm
Re: My SepTandy project for 2023
Still mind boggled!
-
Danniielle
- Site Admin
- Posts: 187
- Joined: Sun Jul 23, 2023 7:40 pm
- Location: Adelaide
- Contact:
Re: My SepTandy project for 2023
Cheers John. I'll have an update to post here shortly. I'm about to continue work on my laser powered flux capacitor and this particular CoCo is integral to its operation.